akdemir from Kaf CS on Vimeo.


This machine is mainly used for roll packing spring units to save shipping and storage cost. Spring units to be covered by wrappings material ( Kraft paper “Spring paper e.t.c). It reducing unit area of spring units during transportation and storage by 1/14 ratio and for preventing collapses in spring system which may occur during use.


Teknik Detaylar

PLC controlled operator control panel
Touchpad TFT screen panel for operation control
Speed adjustment control with driver
Automatic wrapping material cutting and hotmelt gluing system
Spring unit winder cylinder dancer system
Compression adjustment according to specifications of spring to be rolled
Types of springs to be rolled; Bonnell, Pocket. (Standard spring units)
Maximum 200cm wide of spring unit to be packed
High of  spring unit to be packed; Maximum 18cm for bonnell and 22 cm for pocket
Ability to roll spring units included Flat (lOxl.4mm) border frame or not included
Recommended roll diameter is 50cm. But it is able to roll maximum 65cm diameter
Ability to roll maximum 12 rolls per hour
Bobbin holders (ø75mm) wrapping material with air shaft
Ability to attach two pieces wrapping material / bobbin (equal or different in size)
Ability to attach maximum 80cm diameter of wrapping material roll
Automatic wrapping material attachment on to winder cylinder
Automatic spring unit feeding system
Ability to determine and count number of spring unit to be rolled
Spring unit in-feed alignment unit mounted on feeding system
Spring unit feeding interval signalization system
Warning system indicating completion of required number of spring unit
The machine stops automatically when the wrapping material runs out